TherGlass Concrete TOP COAT

Specifications and Application Form

TherGlass Concrete ^®   TOP COAT   is one of the products that make up the repair system for existing concrete structures that present water leaks, so it is applied as a second reinforcement layer, on the base already prepared with TherGlass ^®  Concrete   BASE COAT.

In case of direct application to the substrate and as a single layer replacing bituminous emulsions, the following instructions must be followed:

• The concrete to be treated must be clean and open-pored.
• Remove surface grout, loose or disintegrated parts, dust, dirt, grease, release agents, paint, etc.
• It is recommended to clean with sandblasting, pressurized water, steel bristle brush, mechanical brushing with a needle gun, etc.
• It's advisable to start the mixture with a portion of the planned water and blend the product at low speed for a few minutes. Always follow the powder-in-water method, never water-in-powder.
• The rest of the water will then be added until the required fluidity is obtained, mixing for a few minutes.
• Mix with a slow electric mixer or a blender for a few minutes, and in any case, until you obtain a smooth, homogeneous paste, without lumps and with the consistency required for each case.
• The mixing ratio is 5 parts  TOP COAT  to 2 parts water ,  always by volume.
• You should only prepare the amount that you can use within 20 minutes of mixing.
• The substrate must be moistened to saturation, without flooding, before applying  TOP COAT.
• Once mixed, it can be applied with a brush, long-haired roller or mechanical spraying, in any case spreading it until the entire surface is evenly covered.

Important:

• Shake the mixture frequently during application.
• If the mixture remains consistent in the bowl, do not add more water, beat again and it will regain its initial consistency.
• During the three days following application and once the product has set initially, it should be cured by spraying it with water 2 or 3 times a day. In hot or windy conditions, double the spraying frequency, i.e., between 4 and 6 times.
• To achieve maximum penetration of the crystals into the concrete structure, the surface to be treated must be saturated with water before and after application.

Cleaning

Fresh tools and implements can be cleaned with water. If the material has hardened, it can only be cleaned mechanically.

Dosages and Consumption

The dosage of  TherGlass ^®  Concrete   TOP COAT   is:

• From 500 to 800 gr/m ²  per coat applied as a surface and reinforcement treatment on the already prepared base of TherGlass® Concrete  BASE COAT.
• Consumption is theoretical and depends on the roughness of the substrate and other specific conditions of each project.
• To determine exact consumption, prior tests must be carried out on site.

Storage

Protect from sunlight and extreme temperatures. In tropical climates, the product should be stored in a cool place.

In cold climates the product should be stored at a temperature ≥ 5°C.

TherGlass Concrete ^®   TOP COAT,   has a shelf life of 12 months from its date of manufacture, if stored correctly and in its original packaging.

Safety and Health

TherGlass Concrete ^®   TOP COAT   is an alkaline product and contains cement.

• Irritates skin, eyes and respiratory tract
• Avoid contact with eyes and skin.
• Use work protection measures, such as a mask, gloves, and protective glasses.
• Keep out of reach of children.
• For more information see the safety data sheet (SDS).